Analog Phones with Remote IP Interface

Analog Phones with Remote IP Interface

IP Communication System

This solution includes any of our standard 2100 Series SmartPhones with our 2100-VOIP2CS IP Interface Device. This will allow you to access your customer's SIP phone system utilizing a standard, fully code compliant phone. Available as a complete system or retrofit an existing RATH® SmartPhone in the field.
Ideal for single phone installations either in a new construction project or when a building owner has upgraded their phone system to IP.
2100-VOIP2CS IP Interface
2100-VOIP2CS IP Interface
1.12" H x 4" W x 4" D

How it Works
Analog Phones with Remote IP Interface diagram
Stand Alone Analog Elevator Phones with Remote IP Interface animation
Click to view:
Required system components and wiring
Duration: 1:04 min



Interface Features:
  • Allows up to (2) RATH® 2100 series phones on an IP phone system
  • Phone line verification included
  • Install either in the machine room or a phone room
  • Simple to configure to your customer's IP system (requires a laptop)
  • Can place a call on a Cisco Network or cloud based service provider
  • Includes two FXS ports (one LAN and one WAN)
  • VoIP Protocols: SIP v2, SDP, RTP, and RFC 2833
  • Network Protocols: IPv4, TCP, UDP, DHCP, SNTP, STUN, HTTP, and PPPoE
  • Connections: FXS RJ11 and WAN RJ45 (10/100 BaseT)
  • Power Consumption: 5w

Code Compliance:
  • FCC Part 15 Class B Compliant

Power Requirements:
  • 120vac from a backed up power source or RATH® RP7700100

Wiring Requirements:
  • Requires a standard copper run between the elevator phone and 2100-VOIP2CS
  • Connect the elevator phone to 2100-VOIP2CS via a standard RJ11 jack and to SIP phone system via a standard RJ45 jack (maximum wire run of 300' between 2100-VOIP2CS and Network Switch)

Specifications:
  • Environmental: 32°F - 13°F
  • Warranty: 2 years

Downloads:


Analog Phones with Remote IP Interface